REBUILT 300 Ton Verson SSDC Press
$189,500.00 USD
ConditionUsed
1 available
300 TON VERSON STRAIGHT SIDE ECCENTRIC GEARED MECHANICAL PRESS, 96" x 54" bed area, 12" stroke, 30 SPM, Mechanically Rebuilt slide assembly, Clutch Assembly, Counterbalances, and Crown Assembly. Replaced all bushings, bearings, seals, packings, clutch liners, etc..
1) Complete Clutch/Brake rebuild, with all new seal and packing, liners for clutch and brake and new springs. Reassembled and tested and warranted.
2) Complete rebuild of (2) Air Counterbalances with all new seals, packings, guide bushings, etc..
3) Slide Assembly disassembled and replace all wrist pin bushings and fit to wrist pins. Go through the entire adjustment housings and make sure that everything is in good working order.
4) Update the entire lubrication and air system, replace any lube lines or air regulators and filters. Test pump and motor and make sure everything is in good working order.
5) Complete disassembly of crown assembly; with replacement of connection arm bushings and main bushings. Remachine both connection arms to ensure that everything is machined to new clearances.
Note: This quoted price does not include any work being performed on the electrical controls. The controls are original relay logic, with some Wintriss components added through the years, and should require upgrade/replacement.
Recondition Explanation:
Complete Clutch/Brake Recondition
Includes all new Seals Packings, bearings throughout
All New Liner assemblies ordered from BCN; installed
All New Springs
Complete Recondition of counterbalance assemblies;
All new seals, packings and guide bushings
Lightly honed barrels and polished piston and rod
Reassembled and tested for proper operation
Slide Assembly
Machined bottom of slide to parallel
Remachined bottom connection arm and installed all new wrist pin bushings
and wrist pins. Properly fit to Adjustment Screw.
Checked Adjustment screw and adjustment nut to insure proper fit.
Cleaned out inside of slide and reassembled components
Replaced Wear liners with all New Micarta Liners
Machined all (4) Gibbs assemblies
Machined top and bottom of bolster plate
Checked main eccentric gears and condition was good
replaced Main and Upper Connection bushings with New Bronze material
Tested all Lubrication and Air System to insure in proper working order
Air Clutch and Brake
Air Counterbalances
Palm Buttons
Motors and Controls
Wintriss Smart Pac Controls
Wintriss Programmable Outputs
SICK Light Curtains
Lubrication System-Recirculating
We use cookies to improve your experience. Privacy Policy.